How To Clean Dry Erase Board Without Damaging

Download Article

You can erase old marks from a dry erase board using many safe, non-abrasive household items. Many simple products in your kitchen pantry and under the bathroom sink can remove the toughest stains. Cleaning your board can be very simple and you won't even need too much elbow grease.

1

Try peroxide. Pour some peroxide directly on the old marks. Wipe the peroxide off with a cloth or paper towel. You might need to rub the board again with a clean cloth or paper towel to fully remove the marks.
2
Use rubbing alcohol. Wet a sponge with alcohol and rub it into the stain. Dry the board with a clean, dry cloth. Use 99% or 90% isopropyl rubbing alcohol for the best results.^[1]
- You can put rubbing alcohol directly on a paper towel or tissue and rub that on the old marks.
- Many hand sanitizers contain rubbing alcohol. Rub them directly on the old marks and wipe off of the board.
- For tough stains, rub a few drops of isopropyl alcohol around with your finger on the old marks. Use enough alcohol to leave a thin layer. Allow it to sit for a few seconds and then wipe dry.
EXPERT TIP

Michelle Driscoll is the Owner of Mulberry Maids based in northern Colorado. Driscoll received her Masters in Public Health from the Colorado School of Public Health in 2016.

Michelle Driscoll, MPH
House Cleaning Professional

Michelle Driscoll, a cleaning expert, notes: "Rubbing alcohol or hand sanitizer can also be used to remove permanent marker from a dry erase board!"

Advertisement
3
Draw over the old marks with a dry erase marker. Slowly and carefully draw over what you want to erase with a dry erase marker. A dark-colored marker will work most effectively. You might need to repeat this several times.^[2]
- Erase what you've written over as you normally would.
- This will work well to erase permanent marker from the dry erase board.
4

Apply neutral shoe polish. Rub neutral (no color) shoe polish onto the old marks. Buff the polish off with a clean cloth. Shoe polish provides a smooth, like-new surface.^[3]

Advertisement

1
Use toothpaste. Rub ordinary white toothpaste onto marks on the board. Wipe clean. Toothpaste contains a very mild abrasive and is water-soluble.^[4]
- This method will also remove permanent marker marks from most smooth, non-porous surfaces.
- Any brand will work.
2
Spray hairspray on the marks. Spray a light film of hairspray on the old marks. Let it soak in for a couple of minutes, then wipe off with a paper towel or cotton rag. Clean off any residual stickiness with soap and water.
- You can also clean off old marks with spray deodorant.
3

Try muscle cream. Clean the old marks with a muscle cream like Ben-Gay. This removes permanent marker stains with only a few wipes. Muscle cream is less abrasive than toothpaste, and it contains alcohol, which makes it a great cleaning agent.^[5]
4
Clean the marks with acetone (nail polish remover). Pour a generous amount of acetone on a sponge or paper towel. Wipe a section of the board. Repeat the process in the same section of the board using more acetone on a new paper towel. Wipe the board clean with a dry paper towel.
- Acetone is combustible. Dispose of the paper towels responsibly.
5

Sprinkle a cleaning powder on the marks. A powdered bathroom cleaner, like Comet or Ajax, can easily remove dry erase marker. Just pour a little bit on a damp sponge, then scrub it over the dry erase board. Wipe the board with a wet cloth or paper towel when you're done.

Advertisement

1
Use vinegar and water. Combine vinegar and water to make a cleaning solution. Wipe or spray it on the old marks. Next, wipe the board with a clean paper towel.
- The ratio of vinegar to water should be 1 tsp (4.9 mL) vinegar to 8 oz. (236.5 mL) water.
2

Make a paste with baking soda and water. Add a small amount of water to baking soda. Rub the paste into the old marks on the board. Thoroughly wipe the paste off with a damp cloth or paper towel. This works well on marks made by permanent marker.
3

Rub the old marks with coffee grounds. Rub damp coffee grounds on the board. They are mildly abrasive and will remove the marks without damaging your board. Clean the board thoroughly after using the grounds. This will prevent the board from turning brownish.
4
Smear margarine on the old marks. Massage margarine onto the board. You will notice that the margarine will slowly change to the color of the old marks. This shows it is working. Wipe the margarine away with paper towel.
- Be sure to remove all of the margarine so it doesn't prevent writing on the board.
- If the stain is more than a year old, put some plastic wrap over the margarine and wait 24 hours before wiping the board clean.
5
Clean the board with car wax. Apply car wax to the marks in circular motions. Wipe the wax off with a clean cloth. This method is very good for removing the most stubborn stains. Car wax conditions the board and leaves the surface like-new.
- Another good solution from the garage is WD-40. It also lubricates and conditions the board.
Advertisement

Add New Question

Question

Can you use Windex to clean a dry erase board?

Michelle Driscoll is the Owner of Mulberry Maids based in northern Colorado. Driscoll received her Masters in Public Health from the Colorado School of Public Health in 2016.

House Cleaning Professional

Expert Answer

Support wikiHow by unlocking this expert answer.

Yes, Windex is safe to use on a dry erase board. However, you want to be sure to only use a soft cloth as you wipe the Windex. Scouring pads, steel wool, or anything abrasive can damage a dry erase board.
Question

How do you clean a dry erase board eraser?

Michelle Driscoll is the Owner of Mulberry Maids based in northern Colorado. Driscoll received her Masters in Public Health from the Colorado School of Public Health in 2016.

House Cleaning Professional

Expert Answer

Support wikiHow by unlocking this expert answer.

Dry erasers are easy to clean. You can mix 1 Tbsp of dish soap with 1 quart of very hot water. Let the eraser soak in the hot soapy water for 20-25 minutes and then thoroughly rinse out the eraser under warm water.
Question

What can I use to "condition" the board after cleaning it? I hear car wax work well, but are there any other methods?

Michelle Driscoll is the Owner of Mulberry Maids based in northern Colorado. Driscoll received her Masters in Public Health from the Colorado School of Public Health in 2016.

House Cleaning Professional

Expert Answer
Question

Can I use vinegar and baking soda?

Michelle Driscoll is the Owner of Mulberry Maids based in northern Colorado. Driscoll received her Masters in Public Health from the Colorado School of Public Health in 2016.

House Cleaning Professional

Expert Answer
Question

Does the toothpaste have to be white?

No, but excessive coloring in the toothpaste could stain the board. Be sure to try it in a small area of the board first.
Question

Can I use window cleaner to clean my board?

Yes, but it doesn't work very well on old marks.
Question

Can I use water to clean my dry erase board?

Yes, when it's not baked on and difficult to get off.
Question

What is something I could use if the marks have been on for 8 years?

Windex. Spray it on and let it sit for a few seconds, then wipe dry. It may take a couple of applications before the marks are gone.
Question

How do I get Sharpie marks off a dry erase board?

Take any kind of toothpaste, put some on a paper towel and scrub the board.
Question

Will hand sanitizer or nail polish remover be effective?

Hand sanitizer is a great way to remove old marks, but do not use nail polish remover.

Ask a Question

200 characters left

Include your email address to get a message when this question is answered.

Submit

About This Article

Article SummaryX

To erase old marks off a dry erase board, wet a sponge with rubbing alcohol and rub it onto the stain, wiping the area clean with a dry cloth. If you don't have rubbing alcohol, draw over the old stains with a new, dark colored dry erase marker, and erase as you normally would. It might take a few tries to remove the mark with this method. If the mark is permanent marker, use a paper towel to rub white toothpaste onto the stains. Then, use a wet towel to wipe the board clean. If you want to learn how to use other products, such as baking soda or hairspray, keep reading the article!

Did this summary help you?

Thanks to all authors for creating a page that has been read 1,959,757 times.

Did this article help you?